Hayden St/Weyers Rd Bend Widening
The petition
Residents draw to the attention of failure of Local Councillor Adam Allen to address issues with required road upgrades/traffic management/foilage maintainence at the Hayden St Weyers Rd bend.
Your petitioners therefore request Council improve/widen the road at the bend that joins Hayden St & Weyers Road. Implement full yellow no parking line marking between the bend and Cotterell Crescent (Northern Side of Rd), remove all foliage from railway side of the road to improve sight lines, and stop impeding traffic heading onto Weyers road from Hayden st.
Council response
Thank you for your petition requesting Council complete road upgrades and tree maintenance at Hayden Street and Weyers Road, Nudgee.
Your request for Council to widen the road at the bend joining Hayden Street and Weyers Road has been considered. The current road width through the bend is 6.7 metres, providing 3.35‑metre-wide traffic lanes in each direction, defined by a marked broken centre line providing guidance for motorists through the bend. The lane widths are deemed adequate for 2-way traffic at this location, and they are in line with lane width requirements for a minor road as per Council’s Brisbane Standard Drawings.
A review of the surrounding road network shows Hayden Street and Weyers Road do not offer any travel time or distance savings for motorists attempting to avoid congestion from the nearby major road network, such as St Vincents Road. Hayden Street and Weyers Road are not subjected to significant non-local traffic use, with most road users residing in or visiting the residential catchment to the north. Motorists within this catchment are generally familiar with the road environment, including the bend. The residential catchment to the east is predominantly accessed via St Vincents Road. Residents also have the option of leaving the precinct via Weyers Road, Queens Road and then onto St Vincents Road.
Weyers Road is approximately 7.3 metres wide and marked with a yellow line on the northern side, between the ‘No Stopping’ sign on the bend and the first driveway. Parking is permitted on the southern side of Weyers Road through this same section, while the remaining road section to the east allows for parking on both sides. Under the Queensland Road Rules, motorists must leave at least 3 metres of clear roadway between their vehicle and other parked vehicles, dividing strips, traffic islands or unbroken dividing lines. This allows large vehicles, such as waste collection vehicles or emergency services, to access local streets.
It is acknowledged that cars parking on either side of a road can create situations where only one vehicle may pass at a time. While this one-lane operation can reduce traffic flow efficiency, it acts as natural traffic calming and helps to moderate vehicle speeds as motorists are required to slow down and negotiate the road safely. This is not expected to unreasonably impact upon safety and implementing any further parking restrictions may increase instances of speeding, which is undesirable. As such, Council has no plans to install additional parking restrictions on Weyers Road.
The bend joining Hayden Street and Weyers Road can operate safely provided motorists drive in accordance with the road rules and exercise due caution when operating their vehicle.
Your request to remove the foliage on the railway side of the bend is noted. A Council officer visited the site on 14 November 2024 and noted that the golden penda tree in front of 4 Pamir Street required trimming. In February 2025, the tree was trimmed to provide a 4.5-metre clearance of the roadway and a 2.5-metre clearance of the footpath.
The trees next to the railway corridor do not require trimming as they already meet Council’s required infrastructure clearances and do not meet the criteria for removal according to Council’s guidelines. You are encouraged to report any further instances of vegetation obstructing visibility on the roadway to Council’s 24-hour Contact Centre on 3403 8888.
Thank you for raising this matter.
Comments · 0
Please log in to post a comment.
Loading comments...