SEATBELTS ON ALL BRISBANE BUSES NOW!
The petition
We draw your attention to the fact that all Brisbane City Council buses DO NOT have any safety belts and still allow passengers on busy bus services, like school and university routes, to stand and there are often falls of passengers onto other passengers. We can no longer stand by and allow our transportation services to have inadequate safety mechanisms where injuries and fatalities could occur and have.
Brisbane residents request that Council implement safety belts in all TransLink bus services and to ban standing passengers, to prevent falls and potentially fatal injuries via removing the standing handles for passengers. This petition is to ensure passenger safety is of the utmost importance to Brisbane City Council and to maintain the modern times we live in where we have to adapt to save lives.
Council response
The Australian Government’s Department of Infrastructure, Transport, Regional Development, Communications and the Arts manages road transport safety standards under the Road Vehicle Standards Act 2018 and the Australian Design Rules (ADR). All road vehicles, including Council’s buses, must comply with the applicable ADRs at the time they were manufactured.
The applicable ADR relating to requirements for seatbelts, the strength of seats and seat anchorages is ADR 68/00 – Occupant Protection in Buses. The ADR specifically states, “This ADR does not apply to ‘Route Service Omnibuses’, or omnibuses with less than 17 ‘Seats’ including the driver and crew, or vehicles in which all passenger ‘Seats’ have a ‘Reference Height’ of less than 1.0 metre.”
As the Council bus fleet operates Route Service Omnibuses and the seats used in the Council bus fleet have a Reference Height of less than one metre, by legislation, the Council bus fleet is not required to be fitted with seatbelts.
Additionally, the seats and the seat anchorages fitted to the Council bus fleet are not designed or structurally capable of withstanding the loads associated with fitting seatbelts. As such, the fitting of seatbelts to the existing seats would increase the risk of injury to passengers than currently exists without seatbelts fitted.
The Queensland Government’s Department of Transport and Main Roads controls legislation specific to standing passengers on buses. The Transport Operations (Road Use Management–Road Rules) Regulation 2009 specifically states, “A passenger on a bus is exempt from wearing a seatbelt while the passenger is a standing passenger mentioned in the Transport Operations (Passenger Transport) Standard 2010 ”.
Furthermore, the Transport Operations (Passenger Transport) Standard 2010 states, “the driver must ensure, if the vehicle is a bus that carries standing passengers, the bus is specifically designed and constructed to carry standing passengers”. To meet these requirements, Council’s bus fleet have numerous vertical stanchions, and handgrips hanging from the ceiling and also provided on the aisle side seat squabs.
Therefore, in accordance with the above legislation, Council buses have been specifically designed to carry standing passengers. Should standing passengers be banned as proposed in the petition, then approximately twice as many buses would be needed during peak hours to meet the current patronage demand. This would significantly impact the supply of buses, as well as generate commercial and cost implications for Council and the rate payers of Brisbane.
Comments · 0
Please log in to post a comment.
Loading comments...