Traffic Calming on the 'rat run' between McLean Parade and Gailey Street in Ashgrove
The petition
Residents draw to the attention of Council a request for traffic calming on the 'rat run' between McLean Parade and Gailey Street in Ashgrove. This area meets the criteria for suitability of Local Area Traffic Management (LATM) being a set of neighbourhood roads, excessively wide and straight without significant hills or bends, with no regular bus service or access to an industrial estate.
The SAM (Speed Awareness Monitoring) device located on McLean Parade recorded 318,147 vehicle movements westwards in the four month period between 1/9/21 and 31/12/21 on this neighbourhood street. This is an average of 2,629 vehicles traveling westwards per day, no traffic count is available from the SAM device for eastbound traffic. This level of vehicular traffic is disproportionate to the number of households in the area.
The SAM device recorded average speeds of 54km/hr initially, and 48km/hr following its introduction. A total of 42,057 vehicles exceeded the speed limit of 50km/h in the four month period. This represents 13.2% of vehicles or 348 vehicles per day exceeding the speed limit. Survival rates for a pedestrian hit by a car at 50km/h are 10%, this increases to 60% at 40km/h and 90% at 30 km/h.
Gailey Street and McLean Parade are on the Principal Cycle Network Plan and are vital links in the Enoggera Creek Bikeway (Gailey Street primarily as the bikeway is frequently flooded). McLean Parade is a significant walking and cycling route for local residents, pupils of numerous local schools and users of Banks Street Reserve and other valuable parklands amenities adjacent to Enoggera Creek.
Your petitioners therefore request that Council modify the streetscape on McLean Parade, Gailey Street and adjoining streets to:
1) Reduce the speed limit to 30km/h in accordance with United Nations guidelines for places where people and traffic mix; or 2) Reduce the speed limit to 40 km/h according to available limits for Brisbane streets; and 3) Introduce chicanes to remove straights; and 4) introduce kerb build outs to narrow the road; and 5) installing raised priority crossings (wombat crossings) on McLean Parade and the side roads to make them safer for people walking and cycling.
Some of these measures are already in place on streets in the area including Davies Road, Atthow Avenue and Bott Street.
Council response
Thank you for your petition requesting Council reduce the speed limit and install traffic calming devices on McLean Parade, Gailey Street and surrounding streets in Ashgrove.
Your request for a speed limit reduction to 30 km/h or 40 km/h is noted. All speed limits across Queensland are determined in accordance with guidelines set out in the Queensland Government’s Manual of Uniform Traffic Control Devices (MUTCD), ensuring that speed limits are set in a consistent and credible manner across Queensland. The speed limit in built-up areas (local streets) in Queensland is 50 km/h unless otherwise signed and is considered appropriate for most local streets in built-up areas throughout Queensland.
A review of the most recent data from the official Queensland Government crash history has not identified a significant crash history on McLean Parade, Gailey Street or surrounding streets in the precinct, indicating a good safety record. Furthermore, there is no notable changes to the road network or land use in the area that would impact on traffic speed. Given this, the request to review streets in this precinct would not provide any demonstrable road safety benefit. Therefore, Council does not propose to undertake an area-wide speed limit review at this time.
It is acknowledged that some motorists have exceeded the posted speed limit when initially passing the Speed Awareness Monitor (SAM) on McLean Parade. However, as the SAM has seen a considerable reduction in speed when motorists pass during successive times, Council is satisfied that the SAM has a positive effect on reducing vehicle speeds.
Speeding is primarily a behavioural issue under the jurisdiction of the Queensland Police Service (QPS). As such, the petitioners are encouraged to raise any concerns with speeding motorists directly with the QPS via the Hoon Hotline on 13 HOON (13 46 66).
Your request for traffic calming devices has been noted. Council considers the installation of traffic calming devices only where there is a combination of a demonstrated widespread issue of non-local traffic using the street and where there is a demonstrated speeding concern.
McLean Parade and surrounding streets are listed in the Local Area Traffic Management (LATM) schedule as one of the potential projects for traffic calming. Funding to progress detailed investigations, design and community consultation will continue to be considered for inclusion within a future budget, as part of Council’s annual budgetary process.
Your request for raised priority or ‘wombat’ crossings have also been investigated. Council investigates all requests for pedestrian crossings in line with the requirements outlined in the MUTCD and in conjunction with Australian Standard 1742.10-2009. There are specific guidelines within the standards to where raised priority and wombat crossings are appropriate with consideration to approach speeds, consistency of active user demand, available sight distance and local environmental factors.
Raised priority crossings are installed where designated off-road bikeways meet side road intersections. In the absence of off-road bikeways through this precinct, a raised priority crossing is not warranted. Wombat crossings are installed to give priority to pedestrians at locations with very high pedestrian demand throughout the day. Such locations are generally next to major transport hubs and/or large shopping centres, or within the Brisbane CBD or other principal activity centres. As McLean Parade and surrounding streets are predominantly zoned for residential land use and have low to moderate pedestrian demand, Council does not support the installation of wombat crossings.
Thank you for raising this matter.
Comments · 0
Please log in to post a comment.
Loading comments...