Upgrade Molloy and Richmond Roads Intersection
The petition
The Molloy and Richmond Roads intersection has become increasingly dangerous. The intersection is particularly busy before and after school drop off and pick up due to motorists going to and from the Cannon Hill State School and St Oliver Plunkett Primary School. Also, during peak hours, traffic coming from Molloy Road experiences very long delays in getting on to Richmond Road resulting in frustration and some motorists act impulsively and dangerously. We therefore call on the Council to install traffic lights at this intersection
We the undersigned residents of Brisbane hereby request that traffic lights be installed at the busy intersection of Molloy and Richmond Roads, Cannon Hill, to improve the safety of this intersection.
Council response
There is a pedestrian crossing located on Richmond Road approximately 12 metres west of the intersection of Molloy Road. This staggered zebra crossing includes a median refuge island which provides a safe point for pedestrians to wait for gaps in traffic to cross the road. This crossing is supervised during school drop-off and pick-up periods. To make motorists aware of pedestrians that may be using this crossing, a number of awareness signs are positioned on both Richmond Road approaches, including pavement markings.
The intersection of Molloy and Richmond Roads has ‘Stop’ control signs and line markings on both the northern and southern approaches of Molloy Road. These controls recognise Richmond Road as the priority traffic route at this location and vehicles travelling on Molloy Road are required to stop and observe oncoming traffic until it is safe to enter the intersection and/or turn onto Richmond Road. Richmond Road is straight with a relatively flat profile at the point of the intersection, providing acceptable visibility on both Molloy Road approaches when vehicles are positioned at the stop-bar of the existing controls.
In September 2017, Council installed a Speed Awareness Monitor (SAM) on Richmond Road on the westbound approach to its intersection with Molloy Road. SAMs promote safety through driver awareness and help minimise speeding on Brisbane roads. This citywide program has seen a marked decrease in the number of motorists travelling over the speed limit after passing the signs, with an average speed reduction of more than 8 km/h across all sites since the program began in late 2013. SAMs are installed for a minimum of one month before rotating to another site, with the footing remaining in place for future site rotations. The next SAM rotation is scheduled for this location on Richmond Road within the 2020-21 financial year.
A traffic count and speed survey undertaken in September 2020 on Richmond Road, approximately 300m to the west of the subject intersection, recorded a two-way 85th percentile speed of 61 km/h, which indicates a good level of compliance with the posted speed of 60 km/h.
In response to your petition, Council officers have assessed the safety of the intersection of Richmond and Molloy Roads. Council has reviewed the most recent data from the past five years using the official Queensland Government crash history for the intersection. There were two reported crashes, however, neither of these could be attributed to the configuration of the intersection. It is acknowledged that the intersection receives increased demand during school drop-off and pick-up times, as is the case with many intersections near schools across the city. However, an assessment of Council’s traffic survey data has determined that neither the intersection of Richmond and Molloy Roads, or the pedestrian crossing, meet the accepted Austroads thresholds for vehicle and pedestrian volumes or accident rates warranting the installation of traffic signals.
Council’s assessment has identified that the intersection configuration is acceptable for the current traffic and pedestrian volumes, and that motorists who are driving with due care and attention can safely navigate this intersection. As a result, there are no plans to install traffic signals at this time
Comments · 0
Please log in to post a comment.
Loading comments...