Skip to main content

Give-Way Sign Speed Reduction Bump

View on the council website (opens in a new tab)
Status: CLOSED, finished
Signatures: 3
Closed: 4 Jan 2019
Principal petitioner: Don Martinez
ePetition number: 620

The petition

Residents draw to the attention of Motor vehicle drivers who fail to give-way or reduce speed at intersections marked with a Give-Way sign

Your petitioners therefore request Install metal-based "speed-bump" on road adjacent to the sign (not road marking) to remind drivers that the Give-Way is "active"

Council response

Thank you for your petition requesting that Council install metal-based speed bumps on roads adjacent to give way signs.

Your request to modify give way treatments across Brisbane has been noted. The road standards which Council follows when installing traffic devices include the Queensland Government’s Manual of Uniform Traffic Control Devices , Brisbane City Plan 2014 , standard drawings, Austroads and Australian Standards, all of which recommend a hump or platform with a minimum width of 3.7 metres. This width allows the axle of a car to safely manoeuvre the hump or platform without scraping the vehicle.

In addition, a speed hump or platform at the point of an intersection would cause a hazard for motorcyclists and cyclists due to the reduced speed while turning, especially in wet conditions. The Austroads Guide to Road Design Part 4A – Unsignalised and Signalised Intersections page 12 states ‘the average grade for vehicles at the stop line should be as flat as possible in order to facilitate acceleration into the major road’.

Due to the likely safety issues associated with the installation of metal humps at give way treatments as outlined above, Council does not support your request to modify give way treatments in Brisbane.

It is noted that regardless of whether give way signage and line markings are installed, motorists are required to give way to opposing vehicles in a number of circumstances as outlined in the Transport Operations (Road Use Management – Road Rules) Regulation 2009. Examples include:

- turning right across the path of an oncoming vehicle at an intersection

- turning left or right at a T-intersection

- moving onto a road from a driveway or land next to the road

- moving off from being stopped on the side of the road

- performing a U-turn

- turning left at an intersection with a ‘left turn on red’ treatment.

Failing to give way appropriately is considered to be poor driver behaviour which is enforced by the Queensland Police Service (QPS). Instances can be reported to the QPS via Policelink on 131 444.

Comments · 0

Loading...

Loading comments...